Step 1
The first step in the entire process is to buy a prop puller to assist you with your project. This particular device will facilitate the removal of the boat propeller, so that you will not have to take it out with your bare hands.
Step 2
Next, you will want to make sure that you know where the boat prop that was removed was located. You can do this by drawing a line with an erasable pen on the old spot. This will ensure that you place the new propeller in the correct position.
Step 3
Once these two tasks are completed you can unscrew the nut that holds the old propeller in place by simply rotating it one blade at a time. It is important to note that you do not want to loosen the item too much at this point.
Step 4
This is where you have a chance to use the prop puller that you just purchased from your local hardware or boating goods store. You just need to pull the previously used boat prop off the shaft with the assistance of your new found helper known as the prop puller.
Step 5
Then you can finish unscrewing the retaining nut, but only when the propeller is untightened from the boat shaft. This will enable to pull off the previously used propeller without incident.
Step 6
Be sure to determine if there has been any damage that was caused to the boat shaft prior to putting on the new boat prop.
Step 7
Finally, ease the boat prop onto the boat shaft while paying special attention to the position of the key way. It is imperative that the boat prop not be forced onto the shaft, as this can cause irreversible damage to either instrument. In short, setting a boat shaft and prop in the correct manner is an extremely doable process. If you just follow the steps that have been outlined above, you will be back on the water in a matter of hours. However, if you are not handy or just do not like to work with your hands; you should just hire someone who knows how to perform the steps in this article. It is great to know that you can make sure that they did an excellent job just by following the steps above.